IEC 62150-2:2010

Fibre optic active components and devices - Test and measurement procedures - Part 2: ATM-PON transceivers

IEC 62148-3:2010

Fibre optic active components and devices - Package and interface standards - Part 3: SFF 20-pin transceivers

IEC TR 62343-6-3:2010

Dynamic modules - Part 6-3: Round robin measurement results for group delay ripple of tunable dispersion compensators

IEC 61280-2-1:2010

Fibre optic communication subsystem test procedures - Part 2-1: Digital systems - Receiver sensitivity and overload measurement

IEC 62150-4:2009

Fibre optic active components and devices - Test and measurement procedures - Part 4: Relative intensity noise using a time-domain optical detection system

IEC 62148-16:2009

Fibre optic active components and devices - Package and interface standards - Part 16: Transmitter and receiver components for use with LC connector interface

IEC 61280-2-3:2009

Fibre optic communication subsystem tets procedures - Part 2-3: Digital systems - Jitter and wander measurements

IEC 62148-11:2009

Fibre optic active components and devices - Package and interface standards - Part 11: 14-pin active device modules

IEC 61290-10-1:2009

Optical amplifiers - Test methods - Part 10-1: Multichannel parameters - Pulse method using an optical switch and optical spectrum analyzer

IEC 61280-2-9:2009

Fibre optic communication subsystem test procedures - Part 2-9: Digital systems - Optical signal-to-noise ratio measurement for dense wavelength-division multiplexed systems

IEC 62007-2:2009

Semiconductor optoelectronic devices for fibre optic system applications - Part 2: Measuring methods

IEC TR 62572-2:2008

Fibre optic active components and devices - Reliability standards - Part 2: Laser module degradation

IEC 61291-6-1:2008

Optical amplifiers - Part 6-1: Interfaces - Command set

IEC 61290-3:2008

Optical amplifiers - Test methods - Part 3: Noise figure parameters

IEC 61290-3-2:2008

Optical amplifiers - Test methods - Part 3-2: Noise figure parameters - Electrical spectrum analyzer method

IEC 61290-11-1:2008

Optical amplifiers - Test methods - Part 11-1: Polarization mode dispersion parameter - Jones matrix eigenanalysis (JME)

IEC 61290-10-2:2007

Optical amplifiers - Test methods - Part 10-2: Multichannel parameters - Pulse method using a gated optical spectrum analyzer

IEC 61290-10-4:2007

Optical amplifiers - Test methods - Part 10-4: Multichannel parameters - Interpolated source subtraction method using an optical spectrum analyzer

IEC 61290-7-1:2007

Optical amplifiers - Test methods - Part 7-1: Out-of-band insertion losses - Filtered optical power meter method

IEC TR 61282-8:2006

Fibre optic communication system design guides - Part 8: Calculating dispersion penalty from measured time-resolved chirp data