Placing Bypass Capable Nodes in Two-Layer Networks

Conference: Photonische Netze - 9. ITG-Fachtagung
04/28/2008 - 04/29/2008 at Leipzig, Germany

Proceedings: Photonische Netze

Pages: 6Language: englishTyp: PDF

Personal VDE Members are entitled to a 10% discount on this title

Authors:
Schlosser, M.; Patzak, E. (Fraunhofer Institute for Telecommunications - Heinrich-Hertz-Institut, Einsteinufer 37, 10587 Berlin, Germany)

Abstract:
In two-layer networks there are a lot of ways to improve virtual and physical topology and capacity allocations in terms of cost. Because switching costs are usually higher in the upper layer, the introduction of bypass links, bypassing the expensive upper layer interfaces, can be beneficial. In the paper we discuss the placement of nodes with bypass functionalities. We use a physical network topology with 50 nodes based on the Germany50 reference network. Our approach for finding the bypass links and the corresponding bypass nodes is based on a mixed integer programming approach with a simple cost model for switching in both layers. Our starting point is a network without bypass functionality. This is basically a one-layer network, as all traffic is switched in the upper layer. In a first step we find the optimum capacity allocations in this network, taking the interface granularities into account. After this we calculate the resulting transit traffic in all nodes. If the transit traffic between two next nearest neighbour nodes is larger than a certain threshold, a bypass link between them is introduced between them. The new virtual (upper layer) topology is then used to optimize the network again. This procedure leads to considerable cost reductions, but is computationally much simpler than a full two layer optimisation including all possible bypass links.